CATIA V5 Drafting Beginner Tutorial – How to create a 2D using Drafting

01/20/2017 by Joe Leave a Comment

A simple drawing of a CATIA V5 Part. You will find how to create an angle dimension, chamfer dimension, length, radius, diameter and angle with degrees and minutes.

For questions please use the comment form.

Leave a Reply Cancel reply

CATIA V5 Tutorial – Electric Motor Rotor Design

The new tutorial it is about a complex shaft design. It this link you can download the execution drawing for this part. You can find how to to read an execution drawing, how to use Stiffener command and some circular pattern.

CATIA V5 Video Tutorial for Beginners #11 – Part Design

The bellow video is about how you can create a simple part using simple commands in CATIA V5 Part Design module. For more questions or videos please check my YouTube Channel and also the CATIA video tutorial section from this blog. If you have some drawings I am open to draw for you in a […]

How to measure weight, volume and surface in CATIA V5

A simple but power-full tool is CATIA V5 is the Mass section, from where you can find very fast the main dimensions and weights of a part or of an assembly. To be more precise is very important to have assigned to each PartBody an material, You need to have on your interface active the […]

CATIA V5 Drafting Beginner Tutorial – How to create a 2D using Drafting

Recent Posts

Contact me

Categories

Reader Interactions

Leave a Reply Cancel reply

Footer

Recent Posts

Contact me

Categories